wiring light fixture bathroom How to install a simple bathroom vanity light Wiring Light Fixture Bathroom Cleaver How To Install A Simple Bathroom Vanity Light Images

Wiring Light Fixture Bathroom Cleaver How To Install A Simple Bathroom Vanity Light Images

Related photos in this diagram:

Other recommended diagram ideas:

Wiring Light Fixture Bathroom - Start via putting in the bare copper grounds from the wall and the mild to the inexperienced screw on the base mounting plate. Subsequent be part of the white wires collectively with a brand new twine nut, then the black wires. Tuck everything smartly into the junction box.

In case you connect the white wire to the alternative white wires at the mild fixture you create a lifeless brief when the transfer is closed this will ride the gfci in case you are downstream from it. Check that the conductors for the switch aren't dead shorting the circuit.

I additionally have 2 white wires. So, i connected the black twine to the black cord on the fixture, and both white wires to the white cord on the fixture and the ground wire from the fixture to the inexperienced screw on the mounting harness.

Once the vintage light is completely removed, decide whether there's an existing electrical container. Older houses are probably now not to have a junction box. Adding one now is wise for structural motives as well as electrical protection. In our case, not handiest did the present mild lack a junction container. But the fixture sat off middle from the replicate because of a wall stud. Ceiling containers are to be had as shallow as ½” for placement proper over a structural unit like our massive reflect. If your light is not at a wall stud, an “old paintings” renovation containers are available with swing out tabs to mount at once to the drywall. Use a 4” hollow noticed to remove the drywall and mount the new field. Be careful to transport wiring out of the way first and most effective reduce deep enough to get thru the drywall.

This eighties light fixture turned into making this loo appearance very dated. Replacing it isn't difficult. Before you start the process, make sure to take those safety precautions: switch off and tape off (or lock out) the breaker to any circuit being worked (turning off the wall switch isn't enough as someone should inadvertently switch it again). Use a non-contact voltage detector to verify the breaker/strength is off. Test all wires as some wiring conventions allow the recent cord color to differ (three way switches and fans); constantly use insulated gear and wear insulated gloves if possible.