Advertisement
wemo light switch neutral wire Before (DISCLAIMER: I am, an electrician....please consult professional if, are unsure) 20 Fantastic Wemo Light Switch Neutral Wire Ideas

20 Fantastic Wemo Light Switch Neutral Wire Ideas

Related photos in this diagram:

Other recommended diagram ideas:

Wemo Light Switch Neutral Wire - Hi, @hnewman . To isolate if the wemo light transfer is a operating unit, we advocate that you attempt to deploy it to some other wall transfer and check if it has the identical trouble because it could be feasible you've got a defective unit. A bit of a one-of-a-kind problem in regard to the inexperienced mild. I've just stressed out up my 3rd light transfer and i observe that after the green mild is on, it isn't as shiny as the other 2 switches. The whole thing else appears to be running excellent, but not positive if i have a situation or no longer. Thanks for any remarks. ?.

Fwiw the complete residence become wired by way of an approved electrician, i am not saying there can not be a hassle, however it is a contemporary domestic and electrical set up.?   i opened a second mild transfer and it had the equal wiring configuration, but i failed to measure it . If so, then you definately is probably capable of get the wemo to paintings if it is now not a gfi covered circuit by using: warm to wemo line in (black), load to wemo swwitched out (black), wemo white and green each to ground. ?the modern-day thru the white is low (it's only the wemo switch itself), however note that belkin does no longer recommend wiring the white to floor.

I set up my wemo light switch nowadays, and it regarded to connect to wifi. I got the app operating. However, the light transfer itself did not characteristic. When i pressed it to show the light on, the mild might come on for a split 2nd and then flip off. Then the wemo app would stop operating. After a minute or so, it'd come returned, and then once i attempted to show the light on, the identical aspect happened. Is that this a defective product or am i doing something incorrect?. I'm assuming the white twine is impartial, and the copper cord is the floor twine. But, i've by no means worked with light switches earlier than, so i haven't any idea if i'm doing it proper or no longer. Since it would not fit the diagram flawlessly i am just guessing on the whole thing.