8 Gauge Wire Subwoofer Popular Amazon.Com: BOSS Audio CXX8, Subwoofer -, Watts Maximum Power, 8 Inch, Single 4, Voice Coil, Easy Mounting (Sold Individually):, Electronics Solutions
Related photos in this diagram:
Other recommended diagram ideas:
8 Gauge Wire Subwoofer - Edit: recap: the grasp amp(br out) is used for the positve speaker wires. The slave amp's (br in) positive speaker wires are used as the terrible speaker wire. Hook each poor speaker cord to the other amp's bad speaker wires. Ideal period for my 2013 ward off dart, handiest thing i might say is i desire the connectors had been stronger as i did end up the usage of my own but all in all very happy and i would without a doubt endorse it for the rate.
Capabilities: comes with all cables and accessories for easy set up of amplifier and subwoofer. As much as 800w. Excessive power and right performance. Increases the energy of your vehicle’s audio device. Low noise and distortion. With a fuse holder to defend the audio system from harm by means of the overload modern-day. That is a complete audio wire package for car amplifier and subwoofer installation. High power and exact performance. It is a superb desire for you. Product homes: package deal: sure gender: male-male safety: non-shielded kind: coaxial application: speaker connector kind: stereo connector a : vga connector b: vga connector colour: green packing: polybag external diameter: 6 model wide variety: none predominant reason: cable vehicle audio, automobile speakers, subwoofer wide variety of cores: 175x0.15 jacket fabric: p.C the largest cord diameter: 6 (mm) specs: energy cable: 8ga cord electricity cable period: 5m earth cord: zero.6m rca interconnect cable: 5m manipulate cable: 5m fuse holder length: approx. Eight.5 * 4.2 * 2.1cm / 3.Three * 1.6 * 0.8in fuse most contemporary: 60a package deal size: approx. 27 * 20 * 5cm / 10.6 * 7.8 * 1.9in bundle weight: 493g / eleven.3oz packing listing: 1 * strength cable 1 * earth twine 1 * manipulate cable 1 * rca interconnect cable 1 * fuse holder 1 * bag of terminals. So if i took 2 twin four ohm subs, 2 wires popping out of the field for each sub, going into all the and - ports for the wires, the amp could read it at 1 ohm as lengthy as it become parallel.
This will appear to be a noobish question, but... If i've 2 d2 subs stressed collectively for a very last load of two ohms at the amp with one fantastic and one negetive terminal used on the amps, and i have another 2 d2 subs wired collectively for a final load of two ohms at the amp with the other wonderful and negetive terminals used, would the ohm load on the amps still be 2, and might i still get the total 6,000 watts? (Saz-3000d's strapped).